RING ALARM INSTRUCTIONS

To DISARM the system:

1. Type in your code

2. Press the DISARM button (NOT the check mark)

***You have 30 seconds from opening the door to disarm the alarm.***

To ARM the system when you’re HOME:

1. Make sure all doors are closed

2. Type in your code

3. Press the ARMED - HOME button when you plan to stay inside and not open any doors.

To ARM the system when you’re LEAVING:

1. Close all doors

2. Type in your code

3. Press the ARMED - AWAY button.

***The alarm will turn on 30 seconds later***

What All the Buttons Mean

  1. Network light - Only lights up during pairing or to indicate errors. If it's red, there is a network communication failure.

  2. Battery light - Indicates battery status. When off, there is plenty of battery power. Yellow means the battery is low, and Red means that the battery is very low. This light blinks green when charging. 

  3. Panic button - Sounds the siren and sends push notifications to emergency contacts when pressed. A signal will be sent to the monitoring service, which will call your emergency contacts at the same time.

  4. Fire button - Sounds the siren and sends push notifications to emergency contacts when pressed. If you have Assisted Monitoring, a signal will be sent to the monitoring service, which will call your emergency contacts at the same time.

  5. Medical button - The Base Station will flash and a push notification is sent when pressed. The siren will not sound, but you will hear the words "Medical Alert Active". If you have Assisted Monitoring, a signal will be sent to the monitoring service, which will call your emergency contacts at the same time. 

  6. Motion sensor - When power save mode is off*, this sensor is used to detect motion near the Keypad and light up when needed.

  7. Disarmed Mode - Enter your access code and press to disarm your Alarm system when arriving home.

  8. Home Mode - Enter your access code and press to arm your Alarm system in Home Mode when people or large pets are in the home. Also used at night to secure your home while you sleep.

  9. Away Mode - Enter your access code and press Away to arm your Alarm system when no one will be home. 

  10. Light Bar - Used to indicate remaining time during entry and exit delays.